Board-to-Cable Connector "FI-DP Series"
Compatible With High-Speed Transmission
Such As DisplayPort Has Been Developed

Recently devices like notebook PCs have seen an evolution in high-speed transmission standards such as DisplayPort, along with the acceleration of high-speed signals and high definition graphics.To meet these advances, JAE has developed the "FI-DP Series" connectors as a board-to-cable connector that is compatible with high-speed transmission.

:: Features

• Compatible with DisplayPort (Rev. 1.1a) transmission.
• Height when mated: 2.0mm (42 position), 8.8mm (58 position)
• EMI characteristics and board retention strength is improved by the multiple hold-downs (42 pos: 9 points; 58 pos: 14 points) of the socket connector.
• Socket connector and hold-downs are integrated. Cable connector and base shell touch when mated so cable connector is in contact with the ground on board.
• The pull bar makes removing the cable easier in limited mounting spaces, and also serves as a lock to prevent unmating caused by vibration and shock.
• Compatible with discrete wire and fine coaxial wire (coax / twinax).

:: Applicable market

Notebook PCs, flat-screen TVs, set-top boxes, etc.

:: General specifications

1. No. of Contacts: 42, 58 pos.
2. Contact Resistance: 100 m ohm max.
3. Dielectric Withstanding Voltage: AC500 Vr.m.s. per minute (initial), AC250 Vr.m.s. per minute (after test)
4. Operating Temperature: -40 Deg. C to +80 Deg. C
5. Rated Current: AC, DC each 0.5 A max. per terminal
6. Insulation Resistance: 100 M ohm min.
7. Pitch: 0.5mm
8. Applicable wire: fine wire coaxial 40 to 42 AWG, discrete wire 32 to 36 AWG

:: Materials and Finishes

Socket Side Connector

Cover Shell for Cable Side Connector

Cable Side Connector